Integra Codman CereLink Bedienungsanleitung Seite 25

WIPING, STORAGE, & TROUBLESHOOTING
Wiping Exterior Surfaces
CAUTION: Do not immerse the ICP Monitor or cables in any liquid or allow liquid to enter the receptacles.
CAUTION: Do not sterilize the ICP Monitor.
Wipe the exterior of the ICP Monitor and the cables as necessary with a soft, damp cloth or sponge. Use one of the following to
remove debris, stains or adhesives that stick to the surface:
• Combination wipes (Quaternary Ammonium / Isopropyl Alcohol)
• 70% Isopropyl alcohol
After wiping down, visually inspect the ICP Monitor to ensure labeling is still readable. Do not use the ICP Monitor if labeling is
unreadable. Contact your local sales representative for a replacement.
The ICP Extension Cable can be autoclaved in accordance with its instructions for use, if required by hospital procedures.
Storage
For long term storage of the ICP Monitor, ensure that it is protected from dust and kept in a clean, dry environment with the following
conditions:
• Humidity (RH) range: 15% to 85% (non-condensing)
• Temperature range: 0°C to 50°C
Troubleshooting
You can contact Technical Support at:
Americas
Technical.support@integralife.com
888-772-7378
China
TCS.China@integralife.com
Italy
TCS.Italy@integralife.com
IT +39 02 5778921
Indirect Markets
TCS.Distributors@integralife.com
INT - +33 (0)4 37 47 59 50
Make sure to have the device serial number and the current device software version available. This information can be found in the
"HOME -> SYSTEM INFORMATION" menu. Alternatively, the device serial number can be located in the back of the unit.
TROUBLESHOOTING
System Messages
System Message
Battery not detected.
Power down monitor and attach battery.
Date and time changed!
Remove sensor to prevent data deletion, or
acknowledge to continue.
Low Battery! 15 minutes left.
Connect monitor to power supply.
Australia
service.au@integralife.com
+613 85400400
DACH (Germany, Austria & Switzerland)
TCS.DACH@integralife.com
GER / AUS - +49(0)2102 5535 6200
CHE - +41(0)22 721 23 00
Japan
TCS .Japan@integralife .com
Cause
Battery not connected.
System date and time
modified while the
sensor was temporarily
disconnected.
Approximately 15
minutes of battery charge
remaining.
25
Benelux
TCS.Benelux@integralife.com
BNL - +32 (0)2 257 41 30
France
TCS.France@integralife.com
FR - +33 (0)4 37 47 59 10
UK & Ireland
TCS.UKIreland@integralife.com
UK - +44 (0)1264 312 725
IRL - +353 (0)1 800 901 567
Recommendation
• If battery is connected, replace the battery. Refer to
Replacing the Battery section.
• If problem persists, contact Technical Support.
• Only update date and time before connecting a
new sensor.
• Download stored data to a USB device prior to
reconnecting the sensor.
• Connect monitor to power supply to recharge the
battery.
EN - ENGLISH