Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dimensions
Mounting
In order to expose the module to the minimum mechanical stress it should prefer-
ably be mounted horizontally or vertically on the mounting panel. The module
must be fixed with four screws to DIN 7500 or DIN 7984 (M5 x L).
If possible, the output module should be mounted in such a way that the cable
entry of the plug points downwards.
As the self-heating of the electronics of the unit is dissipated via the housing, suf-
ficient cooling must be ensured in case of "sandwich mounting" of modules.
Electrical connection
Designation
Operating voltage
Ground
Operating voltage outputs
CAN interface
To guarantee the electrical interference protection of the module,
the housing must be connected to GND.
(e.g. to the ground of the vehicle)
To protect the whole system (wiring and output module) the individual electric cir-
cuits must be protected with max. 16 A.
43
5,5
LED
Pin No.
23
01
05
14 / 51
32 / 50
15 / 33
/
INPUT
OUTPUT MODULE
±1
132
15
±1
106,5
Potential
+VBB
S
GND
S
+VBB
O
CAN_H
CAN_L
CAN_GND
CR2513
29
PAGE
Werbung
Kapitel
Inhaltsverzeichnis
