G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung Seite 86

Installation
Connecting audio and RS232 interfaces (depending on model)
Line In Serial
NOTE:
By default, the KVM switch transfers audio data between switches.
In addition, you can enable the transmission of RS232 data and, alternatively,
disable the transmission of audio data (see (De)Activating signals on page 25).
Use an Audio-M/M-2 audio connection cable to connect the omputer's Line-
Line In:
Out interface to this interface
Use the RS232-M/F-2 cable to connect one of the computer's 9-pin serial inter-
Serial:
faces to this interface.
Establishing a connection to the Gigabit Ethernet
Transmission 1 Transmission 2 Transmission 2
IMPORTANT:
The devices use components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE:
Remove the protection caps from the Transmission interfaces and from the
cable plug.
Transmission 1|Tx:
accessory, into this interface. Connect the other end to the Gigabit Ethernet.
Transmission 1|Rx:
accessory, into this interface. Connect the other end to the Gigabit Ethernet.
NOTE:
The activation of the
interface.
Use this interface to establish a redundant transmission connection (link aggregation)
with the Gigabit network.
9 · G&D VisionXS-IP-F-DP-UHR
USB CPU USB CPU
Service Service Network Network Pwr Main Power Pwr Main Power
Insert the LC plug of a fibre optic cable, which is available as
Insert the LC plug of a fibre optic cable, which is available as
Transm. Redundancy
DP CPU DP CPU
Red. Power Red. Power
feature activates the Transmission 2