Measurement Summary Screen; Personalised Printout Window - ATH-Heinl ATH-Lux 3D Bedienungsanleitung

Remarks
• If the adjustment values are not displayed on the caster
registration boxes when this screen opens, make sure
the front targets are levelled.
• If the steering angle procedure has not been performed,
the caster adjustment boxes are displayed completely
empty.
• While adjusting caster, and if the variation is big, the
front target may incline so that it causes a major error
on the toe and setback values calculated.If this condition
occurs at the end of the adjustment, it is recommended
to proceed as follows:
- Select from the F11
caster data" option to (freeze) the caster value displayed
(which is displayed in blue);
- Level the target;
- Select from the F11 menu
caster data" option to unlock the caster value;
- Adjust the toe.
• If a clamp or a wheel has to be demounted in order
to adjust caster, a new compensation must be carried
out on that wheel.
MEASUREMENT
SUMMARY SCREEN
The measurement summary screen (Fig. 34) may be
recalled from the adjustment screens of the front or rear
axles by selecting from the F11
menu
the "Data Summary" option.
This is to display the adjustment measurements (databank,
if present) and the current adjustment values.
The display is divided into two pages, one for the front
axle and another for the rear axles data.
The following keys are active in this screen:
F1 displays the on-line Help function
F2 goes back to the previous screen
® U Ath-h
rheberrecht einl
s : 2022-01, P
tAnD roDUKthersteller
menu the "Freeze
the "De-freeze
G h & c KG, A r
mb o lle echte vorbehAlten
Ath-h G h & c
einl mb
F3
(or Enter) goes to the next screen
F6 displays the data summary of the rear
axle (visible when the data summary
of the front axle is displayed)
F6 displays the data summary of the front
axle (visible when the data summary
of the rear axle is displayed)
F11
Displays the menu with the contextual
function
These are the menu options:
• End of work (Goes back to the starting screen)
• Setup (opens the contextual set-up on the screen
where you are)
• Operating sequence (recalls the alignment
execution setting screen, according to the user's prefe-
rences)
• Help (recalls the Help contextual screen on the
screen where you are)

PERSONALISED PRINTOUT WINDOW

Displayed at the end of a measurement cycle.
Used to set the advertising message that will appear on
the printout, together with the number of copies.
/ D
rUcKfehler UnD technische
KG
o
Ä
nDerUnGen vorbehAlten
25