Error Screen; Vehicle Make Selection Screen - ATH-Heinl ATH-Lux 3D Bedienungsanleitung

Select rear adjustment
Skip execution second steering
Select Saving and printing
The alignment procedure can be customised by combining
the options mentioned above, in a practical and rapid
way, to speed up the operations.
® U Ath-h
rheberrecht einl
16
Skip steering
Steering at 10 20
If adjustable
Always
recalled
Skip second
steering
Second
steering
Do not save
or print
Save
Save and print
Print
G h & c KG, A r
mb o lle echte vorbehAlten
The working procedure can be opened and modified from
any screen you are in, also while the alignment procedure
is being executed.
Use the á and â directional arrows to customise options
and confirm by pressing enter.To exit this screen and save
the settings, press F3, to exit without saving, press F2.
Exiting the screen saving the options established implies
the immediate execution of the procedure selected.

ERROR SCREEN

The screen shown in figure 33 is displayed when there
is a transmission or measurement error.
In these cases, the cause of the error must be corrected
in order to resume normal operation.
However, if this is not possible, press the key
from the starting screen to exit the program correctly.
Afterwards, call in the Technical Support Service.

VEHICLE MAKE SELECTION SCREEN

It allows users to select the make of the vehicle
using the procedures described in the "General
considerations" section.
The following keys are active in this screen:
F1
displays the on-line Help function
F2 goes back to the previous screen
F3
(or Enter) confirms a make selection and
goes to the next screen in the established
operation sequence (databank values
table, compensation, measurement)
F6 modifies a previously entered make
F7
deletes a previously entered make.
This operation is only possible for the
makes from the secondary databank if
there are no associated models.
/ D
rUcKfehler UnD technische
s : 2022-01, P
tAnD roDUKthersteller
Ä /
nDerUnGen vorbehAlten
Ath-h G h & c KG
einl mb o