Data Edit Window; Data Input Window; Chassis Clearance Screen - ATH-Heinl ATH-Lux 3D Bedienungsanleitung

DATA EDIT WINDOW

Edit screens refer to:
- Vehicle makes in databank (makes entered by
the operator)
- Vehicle models in databank (models entered by
the operator)
- Customers on file
- Vehicles on file
- Operators on file
To modify, proceed as follows:
- select the field to be modified using the "Tab" or
"Shift" + "Tab" keys (if there are more than one field in
the window)
- enter a new character/value over the letters or
numbers of the selected item
- re-enter the correct value.
To confirm the changes made and exit this window,
proceed as follows:
- press F3, you will be prompted to confirm saving
of the modified data.
- press F3 to confirm.
If you do not wish to confirm saving, press F2.

DATA INPUT WINDOW

The data input windows refer to:
- Vehicle makes in databank;
- Vehicle models in databank;
- Customers on file;
- Vehicles on file;
- Operators on file.
To enter the data, proceed as follows:
- select the field where data are to be entered using
the "Tab" or "Shift" + "Tab" keys (if there are more than
one field in the window)
- enter a character/value
To confirm the data entered and exit this window, pro-
ceed as follows:
- press F3, you will be prompted to confirm saving
of the data.
- press F3 to confirm,
f you do not wish to confirm saving, press F2.
When entering a new item, the system prompts users
with data for a similar vehicle to simplify the data entry
tolerance.
Remarks
Data for a new customer and/or a new vehicle can also be
® U Ath-h
rheberrecht einl
s : 2022-01, P
tAnD roDUKthersteller
G h & c KG, A r
mb o lle echte vorbehAlten
Ath-h G h & c
einl mb
entered at the end of the measurement and adjustment
procedures for a model chosen from the vehicle databank.
In the print window, a message prompting data to be
entered will be displayed when saving data on request has
been set.A message about the missing data is displayed
when saving data in automatic mode has been set in the
set-up . In the print window, select the data input window
from the F11

CHASSIS CLEARANCE SCREEN

After ROC has been performed, if the selected vehicle
requires some databank values to be modified according
to the clearance of the chassis at specific points, the
chassis clearance window is displayed.
The operator must select from the displayed tables, the
clearance values that most closely match those of the
vehicle in question.
To make the selection, proceed as described in the "Ge-
neral considerations" section.
In certain cases it is not possible to make a selection;
the displayed clearance values are "prescribed" values,
i.e. the only correct references for databank values, to be
achieved if necessary by applying weights to the vehicle.
The following keys are active in this window:
F1
displays the on-line Help function
F2 goes back to the previous screen
F3 (or Enter) goes to the next screen in
the established operating sequence.
F11 Displays the menu with the
contextual functions.
/ D
rUcKfehler UnD technische
KG
o
menu.
Ä
nDerUnGen vorbehAlten
21