Databank Summary Screen; Compensation" (Roc) Screen; Push Mode Roc" Execution - ATH-Heinl ATH-Lux 3D Bedienungsanleitung

These are the menu options:
• End of work (Goes back to the starting screen)
• Operating sequence (recalls the alignment
execution setting screen, according to the user's prefe-
rences)
• Help (recalls the Help contextual screen on the
screen where you are)

DATABANK SUMMARY SCREEN

Shows the databank values for the selected vehicle and
allows the rim diameter to be changed using the Page á,
Page â keys (fig.27).
The following keys are active in this screen:
F1 displays the on-line Help function
F2
goes back to the previous screen
F3
goes to the next screen in the
established operating sequence
F11 Displays the menu with the
contextual functions.
These are the menu options:
• End of work (Goes back to the starting screen)
• Setup (opens the contextual set-up on the screen
where you are)
• Operating sequence (recalls the alignment exe-
cution setting screen, according to the user's prefe-
rences)
• Help (recalls the Help contextual screen on the
screen where you are)
® U Ath-h
rheberrecht einl
22
G h & c KG, A r
mb o lle echte vorbehAlten
"COMPENSATION"
(ROC) SCREEN
Used to select and execute the procedure to compensate
for the rim off-centre and off-plane following the mode
set by the selected method.
The following ROC options are available:
• Push Mode ROC
• Skip Roc
• Recall Roc
The following keys are active in this window:
F1
displays the on-line "Help" function
F2
goes back to the previous window
F11
Displays the menu with the contextual
functions.
These are the menu options:
• End of work (Goes back to the starting screen)
• Help (recalls the Help contextual screen on the
screen where you are)
"PUSH MODE ROC"
EXECUTION
• Make sure the wheels rotate freely.
• The procedure starts automatically. The four hourglasses
displayed on the screen indicate the beginning of the
measurement; the hourglasses and the "OK" message
displayed on the four wheels indicate the beginning of
the saving of the initial position (0°) for all the wheels.
• Push the vehicle as indicated (fig.30) until the wheels
complete a rotation of about 30°, or until the "STOP"
message is displayed.
• Wait until the "OK" messages are displayed, which in-
dicates the beginning of the saving for all the wheels.
• Take the car to the initial position making the wheels
complete a rotation of about 30° in the opposite direc-
tion, until the "STOP" message is displayed again.
• Wait until the "OK" messages are displayed, which indi-
cates the beginning of the saving of the "0°" positions
for all the wheels.
At the end of the compensation procedure, a window
/ D
rUcKfehler UnD technische
s : 2022-01, P
tAnD roDUKthersteller
Ä /
nDerUnGen vorbehAlten
Ath-h G h & c KG
einl mb o