Switching The Aligner On And Off - ATH-Heinl ATH-Lux 3D Bedienungsanleitung

1) Protective Cover
2) Camera
3) Light indication Card, consisting of infrared LEDs and
LED indicator lights.
Light Indications cards (Fig. 5)
Around each camera is placed the card equipped with
infrared illuminators and some colored LEDs, which are
used to provide useful information to the user.
The following table shows the conditions indicated by
colored LEDs:
LINK LED (bi-color, illuminated in red or green):
There are 4 external LEDs that indicate the status of
the locking target.
RG1) LINK LED for the front left target
RG2) LINK LED for the front right target
RG3) LINK LED for the rear right target
RG4) LINK LED for the rear left target
Operation:
GREEN LED ON = THE TARGET ACQUISITION IS OK.
THE TARGET IS LOCKED.
RED LED ON = THE TARGET ACQUISITION IS NOT
OK. THE TARGET IS NOT LOCKED. ANY PROBLEMS ON
TARGET.
DIRECTION INDICATORS LED (illuminated in
blue):
These LEDs indicate the operations to be carried out by
the operator during operation of steering and ROC.
B1) LED indicator "forward", used in the procedure of the
ROC. When lit, it indicates forward to push the vehicle.
B2) LED indicator "right", used in the steering procedure.
When lit, it indicates to steer to the left.
B3) LED indicator "back", used in the procedure of the
ROC. When lit, it indicates to push back the vehicle.
B4) LED indicator "left", used in the steering procedure.
When lit, it indicates to steer to the left.
Notes:
The STOP condition for storage of data is signaled
by the simultaneous activation of all 4 blue LEDs. This
condition happens during the phases of steering and
ROC, during the storage of data.
In standby mode, all the LEDs of the cards flash
alternatively.
® U Ath-h
rheberrecht einl
s : 2022-01, P
tAnD roDUKthersteller
G h & c KG, A r
mb o lle echte vorbehAlten
Ath-h G h & c
einl mb
SWITCHING THE ALIGNER ON AND
Turn on the aligner by setting the switch (A, fig. 6) to
"I" (On).
Then wait until the starting screen is displayed (fig. 24).
To switch the aligner off correctly, proceed as follows:
• go back to the starting screen (fig. 24);
• Access the menu by pressing F11
• Select the "turn off" option
• Confirm the switching off by pressing F3
CAUTION
Never switch off the machine when there is a page other
than the logo page displayed because such an action
might damage the PC.
Should this occur, when the PC is switched on again, the
software will request the user to press any key to perform
the "SCANDISK" operation.
This operation is used to check that the PC has not been
damaged and, if necessary, to update some files that
might have been damaged.
At the end of the process, if the program reboots normally,
then no problems have occurred.Instead, if any message
appears blocking the program start-up procedure, contact
the nearest technical assistance centre.
/ D
rUcKfehler UnD technische
KG
o
OFF
Central unit
Ä
nDerUnGen vorbehAlten
13