Inhaltsverzeichnis
Werbung
3.2
Scope of delivery
INFORMATION
The drilling- milling machine is delivered pre-assembled.
Compare the scope of delivery with the attached packing list.
Check the status of the machine immediately upon receipt and claim possible damages at the
last carrier also if the packing is not being damaged. In order to ensure claims towards the
freight carrier we recommend you to leave the machines, devices and packing material for the
time being in the status at which you have determined the damage or to take photos of this sta-
tus. Please inform us about any other claims within six days after receipt of delivery.
CAUTION!
Basically, all tools, especially milling tools, are to be fastened in the spindle with the
tightening rod and also loosened again. A reduction sleeve MT4/MT3 with ejector tab,
which may be included in the scope of delivery, is not suitable for use on this drilling
and milling machine. The spindle sleeve itself does not have a continuous gap in order
to be able to use an extraction wedge there. This possibly installed reducing sleeve with
the ejector tab must be loosened again with the tightening rod. This can damage the
thread of the tightening rod. The drive-out wedge included in the scope of delivery is
intended for this reducing sleeve itself, in order to be able to undo a connection made in
it.
A reducing sleeve MT4/MT3 with thread M16 for the tightening rod is optionally available under
article no. 3350314.
3.3
Set-up and assembly
3.3.1
Installation site requirements
The workplace for operating, maintenance and repair must not be restricted.
The mains plug of the drilling- milling machine must be freely accessible.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights (available as
an option) must be used.
3.3.2
Load suspension point
WARNING!
Danger of crushing and overturning. Proceed carefully when lifting, installing and
assembling the machine.
Lock all clamping levers on the drilling-milling machine before you lift it.
Fix the load lifting gear around the drilling-milling head. Use a lifting sling for this purpose.
Make sure that the attached load does not cause damage to components or paint.
EN
MB4
64
Translation of original instruction
Version 1.0.1 - 2021-11-18
Werbung
Inhaltsverzeichnis
