Swivelling The Drill-Mill Head - Optimum OPTImill MB 4 Betriebsanleitung

4.11

Swivelling the drill-mill head

The milling drilling and head can be
swivelled to the right and to the left. There
three screws are to loosen.

Turn the drill-mill head to the desired
position.

Retighten the fastening screws.
ATTENTION!
The drilling-milling
swivelled significantly further. Gear oil
may leak out due to further swivelling.
CAUTION!
If the screws are completely unfastened, the drill mill head might fall down.
When slewing the working head, only unfasten the screws as far as necessary to be able
to perform the settings. After having set the slewing angle, retighten the fixing screws.
Version 1.0.1 - 2021-11-18
Clamping bolts
head can be
Translation of original instruction
Img.4-5: Drill depth stop
Img.4-6: Clamping screws
MB4 EN
73