Cover Ring Assembly - INTORQ BFK458 Originalbetriebsanleitung

Mechanical installation
1. Mount the intermediate flange with the four screws in the threads of the first magnet housing.
All other steps for mounting the second brake are carried out as described in the section Mounting the
brake, Page 38.
5.9

Cover ring assembly

Fig. 19: Cover ring assembly
A
D
G
1. Pull the cables through the cover ring.
2. Slide the cover ring over the stator.
INTORQ | BA 14.0168 | 08/2019
Notice
Requirements:
¾
The first hub has to be mounted on the shaft!
¾
The first brake must be completely mounted!
¾
The air gap must be set!
NOTICE
With the double spring-applied brake design, when working with braking torques which are
greater than the standard braking torque, you need to check the screws connecting the
first brake. Please consult with INTORQ first!
Cover ring
Armature plate
End shield
NOTICE
The cover ring may only be used in conjunction with a flange or friction plate!
B
Socket head cap screw
E
Sleeve bolt
H
Friction plate
C
Stator
F
Flange
46