INTORQ BFK458 Originalbetriebsanleitung Seite 117

Mechanical installation
5. Check the air gap near the screws using a feeler gauge. These values must match the specifications
for s found in the table Rated data for air gap specifications, Page 23.
LN
Fig. 13: Adjusting the air gap
6. If the measured value s
head cap screws slightly and adjust the air gap (turn the sleeve bolts using a wrench).
7. Use a torque wrench to tighten the socket head cap screws (refer to the Figure Tightening the screws
with a torque wrench, Page 39).
INTORQ | BA 14.0168 | 08/2019
Notice
Do not push on the feeler gauge more than 10 mm between the armature plate and the stator!
is outside of the tolerance s
L
NOTICE
Tightening torques: refer to the table Rated data: screw kit for brake assembly on separ-
ately screwed-on flange, Page 24.
, readjust this dimension. Loosen the socket
LN
40