For Your Safety - Henkel LOCTITE UVALOC 1000 Bedienungsanleitung

1 Please Observe the Following
1.3

For your Safety

IMPORTANT! DO NOT OPERATE THE UNIT BEFORE READING THIS SECTION.
DANGER!
Removing, bypassing or putting out of operation of the safety devices can result in
radiation damage to persons and damage to the unit and is therefore prohibited!
Damage to the power cord or the housing can result in contact with live electrical parts.
Check the power cord and the unit before each use. If the power cord or the unit is
damaged, do not operate! Replace a damaged power cord with a new one.
Disconnect power supply before opening the housing!
Never operate system while lamp housing is open!
High voltage is generated by the ignition capacitor inside the lamp housing!
The UVALOC System generates high-intensity UV radiation that, on direct exposure, can
damage skin and eyes in a short time.
In case of malfunctions in the regular operation of the shutter, avoid direct exposure of
the skin under all circumstances, in case of any other shutter malfunction, too!
Broken lamps will release mercury!
Proceed as follows:
Remove all persons at once from the immediate vicinity of the UVALOC System to
prevent breathing of mercury vapours. The room should be thoroughly ventilated
(15 – 20 minutes). When the unit has cooled down, mercury residues should be removed
using absorption systems available from specialty chemicals suppliers.
CAUTION!
The lamps contain mercury. Do not dispose with household trash.
Disposal as hazardous waste required.
To avoid injury, do not touch the shutter while cure chamber is open. This part may reach
up to 90°C during operation.
Only authorized Henkel service staff is permitted to open and repair the unit, except for
replacing the UV bulb and the air filter.
The UV lamp and the air filter must be replaced by qualified personnel only.
Do not touch the glass bulb of the UV lamp. Etched fingerprints on the envelope will
reduce the service life of the lamp significantly.
Cleaners containing ammonium chlorides must never be used to clean the lamp, and not
in the same room as the UVALOC 1000 system, too.
No modifications or other changes to the UVALOC equipment are permitted.
Observe general safety regulations for the handling of chemicals!
Follow the manufacturer's instructions!
®
Request a safety data sheet for the Loctite product used!
7