Display Language - Henkel LOCTITE UVALOC 1000 Bedienungsanleitung

4 Installation
After reaching full power, the display in
the home menu changes to exposure
mode.
Here are displayed:
? Going to start screen with basic data.
500 W / 1000 W: Selected power.
In standby mode the power is always
500 W, for a 1000 W exposure the
power is switched up before the shutter
is opened and briefly heated up to the
higher power, factory setting 5 s.
Additionally for the chamber version:
- Before starting the exposure: Close door , if the door is open. Exposure start is only
possible with closed door.
- After the end of an exposure: Take out part .
The messages disappear automatically as soon as the door is closed or the part is
removed, i. e. the door is opened, and only serve as a note for the operator.
4.6

Display Language

• Tap the globe symbol, then the desired
language.
The following languages are available:
English, German, French, Portuguese,
Italian and Spanish.
Notice!
The language can be changed at almost
any time.
Exceptions: A dialogue box is open, this
has priority over all other control
elements, or one of the few masks is
active, which covers the menu.
In this case, close the overlaying mask with the back symbol.
26
Last measured UV level.
Display of the set exposure time in timed mode or
Operating mode is continuous operation (usual for the tunnel version).