Transport - AL-KO CSA 1820 Betriebsanleitung

GB
Malfunction
Motor running, but the saw
chain does not move.
Only sawdust is thrown out,
rather than wood chips. The
pole-mounted pruner must be
forced through the wood.
Tool vibrates unusually.
Rechargeable battery operating
time is significantly shorter.
Rechargeable battery cannot be
charged.

10 TRANSPORT

Before transporting, carry out the following mea-
sures:
1. Switch off the tool and remove the recharge-
able battery.
2. Fit the chain guard.
3. Remove the saw head from the basic tool.
4. In vehicles: Secure the saw head to prevent
tipping over, damage and leakage of chain
oil.
Rechargeable battery "B125 Li" (Art. No.
113896)
NOTE The nominal energy of the recharge-
able battery is more than 100 Wh. Therefore, ob-
serve the following transport instructions.
The li-ion rechargeable battery contained in the
appliance is subject to the hazardous goods law,
but can be transported under simplified condi-
tions:
■
The rechargeable battery can be transported
on public roads by the private user without
38
Cause
The oil entry hole and/or
groove of the chain bar are
dirty.
The saw chain is tensioned
too tightly.
Tool faults
The saw chain is blunt.
Tool faults
The service life of the battery
has expired.
Rechargeable battery con-
tacts are dirty.
Battery or charger is defec-
tive.
Battery is too hot.
further conditions provided it is packaged for
retail sale and the transport serves personal
purposes.
■
Commercial users who carry out the trans-
port in connection with their main activity
(e.g. delivery from and to building sites, or
demonstrations) can also take advantage of
this simplification.
In both cases, it is essential to take the mandato-
ry precautions mentioned above to prevent any
leakage of the contents. In other cases, it is es-
sential to comply with the regulations of the haz-
ardous goods law. In the case of non-compli-
ance, severe penalties can be imposed on the
sender and possibly the transporter.
Additional notes on transport and shipment
■
Only transport or send the li-ion rechargeable
battery in an undamaged condition.
■
For transporting the rechargeable battery, on-
ly use the original cardboard box or a suitable
hazardous goods cardboard box (not re-
quired for rechargeable batteries with a nomi-
nal energy less than 100 Wh).
Remedy
Clean the oil entry hole and
groove of the chain bar.
Check the chain tension. Re-ten-
sion the saw chain.
Contact a service centre of the
manufacturer.
Contact a service centre of the
manufacturer.
Contact a service centre of the
manufacturer.
Replace the battery. Use only
genuine accessories from the
manufacturer.
Contact a service centre of the
manufacturer.
Replace the rechargeable bat-
tery or charging unit. Use only
genuine accessories from the
manufacturer.
Allow the battery to cool down.
Transport
CSA 1820