Clean The Pressure Sprayer; Store The Pressure Sprayer; Troubleshooting - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

handle at the opening of the container
15
Press the spray trigger
ual pressure over the opening of the container
.
3
I f the nozzle seems to be blocked, do not try
to blow it free with your mouth.
Note: Clean the pressure sprayer after each use!
Empty the bottle after each use.

Clean the pressure sprayer

The pressure sprayer shall be washed in an
allowed site.
L oosen the spray nozzle
pressure regulating valve and clean under
22
running water.
L oosen the nozzle cap
clean under running water together with the
inner parts of spraying sheet
split sheet , seal washer sheet
33
I f the spray nozzle
clean it by pushing a needle through it.
F lush through the pressure sprayer, pressure
regulating valve
22
Remove the spray handle
sprayer and disassemble. Clean under running
water together with the filter
ø18.5mm . Pls. use brush for clean the
39
filter (Fig J).
19
Take out the filter screen
water with brush.
The surface and inner part should be cleaned
with high pressure injection water till drainage
become clean (Fig. K). After clean, always
kick the spray tube
holder (s. fig. I) for transport or storage.
9
After operation and cleaning of product, al-
ways change clothes and wash those exposed
part of body such as hands and face. In case
of toxic pesticide and germicide, a shower after
operation is required to ensure safety.
to release the resid-
17
, , ,
23 24 25 26
, , ,
23a 24a 25a 26a
, ,
23b 24b 25b
.
34
, , , is clogged,
23 24 25 26
, pipes and tubes with water.
from pressure
15
and O-ring
19
under running
31
onto the spray tube
20

Store the pressure sprayer

.
3
pressure still present in the container
by following the step of "Emptying the pressure
sprayer and disposal of spray solution"and"
Cleaning and care".
T horoughly clean the device and allow it to
dry before you put it away for the winter. This
will avoid frost damage.
C lip the spray tube
(s. fig. I).
S tore the pressure sprayer in a dry, dust-
free place.
from stock buildings due to the ammonia vapours
(danger of brass cracking), do not fill with
solutions containing nitrogen or phosphates.
, Check the product regularly each year after
winter by using of clean water. Check product
, before each use.
Check the product after each use.

Troubleshooting

If the measures listed below are not successful,
contact the manufacturer.
= Fault
= Potential causes
= Remedies
No pressure is established
in the tank.
The lid of container
into place.
Fasten the lid of container
place.
Fasten the union nut
into place.
The piston
Replace the piston
included spare parts " described in manual.
Split pin
32
Re-tight the split pin
Always release any residual
3
on spray tube holder
20
Do not store the device in live-
is not firmly fastened
1
firmly into
1
, , and
12 14 16
may have been damaged
35
according to " Replace
35
fetch way
on the product properly.
32
after use
9
firmly
21
GB 13