Exchange Of Spare Parts Included - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

Spray nozzle does not spray.
No pressure present.
Generate pressure through the pump
moving the lever handle
The spray nozzle is blocked.
Stop use, unpressured, take care about pesti-
cide to person and environment. Clean the
spray nozzle ,
23
step of "Cleaning and care" section described
in the manual).
No spray in the tank.
Fill with spray.
Filter is blocked.
19
Clean the filter with brush (please refer to the
"Cleaning and care" section).
The seal-ring loose or is damaged.
Re-tighten up or replace.
Rock Lever is too heavy to operate.
Levers is too tight.
7
Check and adjust the levers
Pump charmer
10
Apply lubricant.
Nozzle , ,
23 24 25
blocked.
Stop use, unpressured, take care about pesti-
cide to person and environment. Clean with
brush (please refer to the "Cleaning and
care" section).
Pump is block.
Check the position of lever
Pls. contact its service agent or similarly quali-
fied persons. Failure to do so may result in
hazard.
Exchange of spare
parts included
Protect yourself with suitable
personal protective equipment (PPE) of wearing
eye protection, respiratory protection, appro priate
protective clothing, water-proof gloves and boots
from hazardous substances.
Only use spare parts and ac-
cessories provided by the manufacturer. All other
repairs shall only be carried out by the
14 GB
10
.
6
, , (Pls follow the
24 25 26
.
7
insufficiently lubricated.
, or filter is
26 19
and split pin
7
manufacturer, its service agent or similarly quali-
fied persons. Hazards can arise due to improper
by maintenance (Fig. M).
all parts back together and check the product
before use.
If found damaged
with following part
no.
Lever handle
Seal washer sheet
ø16 mm
34
O-ring ø15 mm
Collet
37
.
32
Aligning buckle
After any replacement, pls. put
Replace with the spare
parts included in the
package
Remove the damaged
8
holder for lever handle
from the holder
8
and replace.
Loosen the nozzel cap
, or
23a 24a 25a
move the damaged seal
washer sheet ø16 mm
and replace.
34
Loosen the union nut
36
from spray tube handle
or the union nut
15
from the pressure regu-
lating value
22
the damaged O-ring
ø15 mm and replace.
36
Loosen the union nut
from spray tube handle
or the union nut
15
from the pressure regulat-
ing value , remove the
22
damaged collet
replace.
Remove the aligning
38
buckle from the
38
levers on the bottom
7
of sprayer and replace.
9
, re-
16
21
, remove
16
21
and
37