Filling The Pressure Sprayer Tank; Changing Of Chemicals; Building Up The Operating Pressure; Spraying - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

Tighten the union nut
tion.
F asten the lid of air chamber
goes.
A ttach the belt hook
A djust the length of belts
buckles and move the belt pads
29
suitable carrying position.
Note: adjust in the same way before wearing
to give even load.
Note: The device must worn as close to the
body as possible and parallel to the spine.
Filling the pressure
sprayer tank (Fig. F)
Only mixing and filling outdoors
or in well-ventiled greenhouse.
Check the volume application rate when filling
the liquid into the sprayer.
Note: Before using the product, check to see
that it is in good condition and free of defects.
C lick the spray tube
holder (s. fig. I).
9
U nscrew the lid of container
wise direction and open.
N ow fill the tank with prepared mixture
through the filter screen
Filter screen is for filtering the solid substance.
31
Note: Fill the tank with only the amount of
liquid that you actually need for that particular
spraying session (not more than 16 l).
N ote safety instructions on the labels of the
spraying pesticides used. Pay attention to the
stated max. concentrated.
A lways request a safety data sheet from the
spraying agent manufacturer.
P lace the lid of container
container and fasten in a clockwise direc-
3
tion clockwise as far as it will go.
in a clockwise direc-
12
as far as it
11
to belt hook holder
27
with the belt
30
for
28
on the spray tube
20
in an anti-clock-
1
carefully.
31
back onto the
1

Changing of chemicals

Pls. follow the step of "Emptying the pressure
sprayer and disposal of spray solution" de-
. scribed in the manual
5
Pls. follow the step of "Cleaning and care"
described in the manual .
C heck the product according to the "Before
use" described in manual.
Pls. follow the step of "Filling the pressure
sprayer tank" described in manual.
Building up the
operating pressure (Fig. G)
G eneral the pressure through the pump
by moving lever handle
and down until the pressure sprayer has been
pumped up to a pressure not exceeding the
maximum permissible operating pressure of
4 bar.
W hen carrying the tank
cess, can generate the pressure by moving
the levels handle
down with left hand if the pressure in the
tank becomes low.
3

Spraying

C arry the pressure sprayer over your shoulder
by the carrying belts
Note: Ensure that the pressure sprayer is
always kept upright. Only when held in this
orientation will the sprayer work properly.
H old the spray tube handle
hand and direct the spray nozzle
or e.g. at a plant.
26
P ress the trigger
Note (Fig. H): For continues spraying, move
the spray lock
tinues spray, move the spray lock
R elease the trigger
process.
Note: When the pressure in the container
is no longer sufficient to spray, pump the
on levers
6
with spraying pro-
3
on levers up and
6 7
.
30
firmly by the
15
,
23
to start the spraying process.
17
backward. To release con-
18
toward.
18
to stop the spraying
17
10
up
7
,
24 25
3
GB 11