Exchange Of Nozzles; Before Use; Bringing Into Use; Attaching The Spray Tube - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

The Pressure Regulating Valve
opened at pressure of 1.4± 0.2 bar, and normally
closed at pressure of 1± 0.15 bar. When the pres-
sure inside the tank
3
sure, the sprayer can start spraying by compressing
its spray trigger . When the pressure is lower
17
than the close pressure, the regulating valve
will shut off automatically and stop spraying. You
shall pressurize the pump
ceed spraying.
Note: Residual pressure still exists in the tank
due to the regulating valve
ing was finished. Loosen the union nut
the spray tube . Open the lid of container
20
move the spray tube toward into the opening of
tank , press the spray trigger
3
residual pressure above the opening of tank

Exchange of Nozzles

Protect yourself from hazardous
substances during exchanging the nozzles by
wearing suitable personal protective equipment
(PPE) (eye protection, respiratory protection,
protective clothing, waterproof gloves and
boots).
CAUTION! Check safe function!
Lossen the nozzle
pressure regulating valve
R eplace and fasten the nozzle
to the pressure regulating valve
26

Before use

Protect yourself with suitable
personal protective equipment (PPE) of wearing
eye protection, respiratory protection, appro-
priate protective clothing, water-proof gloves
and boots from hazardous substances.
CAUTION! Check that the device is function-
ing properly! Check the pressure sprayer be-
fore each use to ensure that it is free of visible
10 GB
is normally
22
increases above open pres-
22
if you desire to pro-
10
, even though spray-
22
and remove
16
1
to release the
17
3
, , or from the
23 24 25 26
.
22
, ,
23 24 25
.
22
damage and is functioning safely. To do this,
carry out the following tests and inspections:
The hose
13
any cracks or appear porous.
Check the container
carry belts
C heck that the hose connections
pipe connection
ing valve
22
are fitted tightly.
C heck that the lid of container
air chamber
3
T rial spraying with clean water and a check
of tank, hose, shut-off and nozzle for possible
, leakage are required prior to operation.
Check that the filter screen
spray tube handle
. screen and filter on spray tube handle
31
are for filtering the solid substance."

Bringing into use

personal protective equipment (PPE) of wear-
ing eye protection, respiratory protection,
appro priate protective clothing, water-proof
gloves and boots from hazardous substances.
Only mixing and filling outdoors or in well-ven-
tiled greenhouse.

Attaching the spray tube

or
(Fig. B–E)
A ttach the conical nozzle
double conical nozzle
to pressure control valve
26
nozzle in a clockwise direction.
A ttached the pressure regulating value
the union nut
the union nut
I nsert the spray tube
handle , then tighten with the union nut
15
C onnect the hose
dle , tighten the union nut
15
or O-rings , must not show
36 39
, the hose
3
for visible damage.
30
12
and , pressure regulat-
16 21
and nozzles
23 24 25
1
are closed tightly.
11
and filter on
31
are not blocked. Filter
19
Protect yourself with suitable
, fan nozzle
23
or four-hole nozzle
25
. Fasten the
22
on spray tube
21 20
.
21
into the spray tube
20
to the spray tube han-
13
.
14
and the
13
and ,
14
or
26
and lid of
19
,
24
to
22
. Tighten
.
16