Emptying The Pressure Sprayer And Disposal Of Spray Solution; Transport Of The Pressure Sprayer; Cleaning And Care - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

container to increase the pressure again
3
up to but not exceeding the maximum permis-
sible operating pressure of 4 bar (see "Build-
ing up the operating pressure").
C lip the spray tube
during work interruptions and breaks.
Note (Fig. I): The nozzle
always on the top position when the spray tube
is clipped onto the spray tube holder
20
A fter spraying, loosen the union nut
remove the spray tube
container , move the spray tube handle
1
toward into the opening of tank
spray trigger to release the residual pres-
17
sure above the opening of tank
residue spray solution, pls. follow the step of
"Emptying the pressure sprayer and Disposal
of spray solution" described in the manual.
Emptying the pressure sprayer
and disposal of spray solution
Always release residual pressure
before transport and cleaning. Protect your-
self with suitable personal protective equipment
(PPE) from hazardous substances. Take pre-
cautions to avoid environmental contamina-
tion from hazardous substances.
Loosen the union nut
spray tube .
20
Open the lid of container
tube handle toward into the opening of
15
tank ,
3
Press the spray trigger
ual pressure above the opening of tank
R emove any leftover spray product from the
tank and the pipes and store it in a suitable
container.
D o not dispose of residues down the drain.
Dispose shall follow the safety introduction
according to the chemical manufacturer.
Always keep the product away
from other people during emptying and dis-
posal.
12 GB
on spray tube holder
20
, , ,
23 24 25 26
and
16
. Open the lid of
20
, press the
3
. For the
3
and remove the
16
, move the spray
1
to release the resid-
17
3
Transport of the
pressure sprayer
personal protective equipment (PPE) of wear-
9
ing eye protection, respiratory protection,
appro priate protective clothing, water-proof
gloves and boots from hazardous substances.
. Only mixing and filling outdoors or in well-
9
ventiled greenhouse.
& empty the container
15
tion.
S ecure the product against falling, overturn,
vibration, extremely high or low temperatures,
direct sunlight and impacts during transportation
to avoid damages.
T ighten the sprayer with lid and all the union
nuts during transport to prevent loss of fuel,
damage or injury.
A lways kick the spray tube
tube holder
age.
Note: Make sure that the pressure sprayer is
always in an upright position.
T ransport after use, clean the device and dry.
Follow the step of "Cleaning and are" described
in manual. Kick the spray tube
spray tube holder
container handle

Cleaning and care

.
yourself with wearing suitable personal pro-
tective equipment (PPE) of wearing eye pro-
tection, respiratory protection, appropriate
protective clothing, water-proof gloves and
boots from hazardous substances.
Note: Even after spraying has ended, there
is still residual pressure in the container
to the pressure regulating valve
it, first loosen the pipe connection
move the spray tube
the container
Protect yourself with suitable
Make sure to release pressure
before transporta-
3
onto the spray
20
(s. fig. I) for transport or stor-
9
onto the
20
(s. fig. I). Carry with the
9
.
2
During cleaning, always protect
. To release
22
16
. Open the cover of
20
and point the spray tube
1
due
3
and re-