Check The Scope Of Delivery; Use - Parkside 316148 1904 Bedienungsanleitung

GB/IE
! WARNING!
Risk of injury!
Never aim the water jet at electrical equipment.
There is a risk of electric shock!
- Do not leave the hose unattended during operation.
- The hose is not suitable as a drinking water pipeline/drinking water
pipeline component.
!
CAUTION!
Risk of slipping!
If the ground is wet, you can slip on the ground and get
hurt.
- Make sure that the ground near the hose is kept as dry as possible.
- Turn the tap ff when the hose is not in use.
!
CAUTION!
Damage to property!
Improper handling of the hose can damage the hose.
- Do not route the hose around corners or edges or along pointy or
sharp objects. The resulting damage can cause the hose to leak.
- Do not place the hose in areas where vehicles travel. Being driven
over can cause the hose to burst.
- Make sure that dirt particles do not block or damage the connec-
tions or get inside the hose.
- When not using the hose: Dismount the hose and let out the remain-
ing water from inside the hose.
- To avoid frost damage, dismantle the hose in winter, drain it and
store it in a dry place.

6. Check the scope of delivery

! CAUTION!
Damage to property!
If you open the packaging carelessly with a sharp knife
20
or other sharp objects, the hose can quickly be damaged.
- Be very careful when opening.
- Take the garden hose and all accessories out of the package.
1
- Check that the delivery is complete (see"3. Scope of delivery").
- Check to see if the garden hose or the parts are damaged. If so, do
not use the garden hose. Contact the manufacturer at the indicated
service address.

7. Use

Attach the irrigation sprayer
- Screw the coupling piece with the inner cross
1
hose , if necessary.
- Slide the thumb lever 9 forward to "OFF" to close the irrigation
sprayer.
- Connect the irrigation sprayer
5
ner cross . To do so, pull the exterior ring downwards, insert the
6
irrigation sprayer and release the ring.
Connect the water tap
- Turn the tap closed.
- If your tap has a G ½" external thread, screw the reducer adapter
on .
4
- Screw the plug system onto the tap or the reducing adapter
3
- Check the tightness.
- Connect the coupling piece without the inner cross
3
system . Then, pull the outer ring downwards, insert the coupling
2
piece without the inner cross
Operation
1
- Unroll the Garden Hose completely before use.
- Turn on the tap only a little at first and increase the water pressure
evenly. The garden hose will roll out.
- Once the Garden Hose is completely unrolled, open the valve on the
6
irrigation sprayer over the thumb lever
"ON".
- To adjust the bundling of the water jet, use the control tip
GB/IE
5
onto the garden
6
to the coupling piece with the in-
2
to the plug
and release the ring.
9
by turning it back to
8
of the
.
4
21