Cleaning And Care; Clean The Pressure Sprayer; Store The Pressure Sprayer - Parkside HG06876 Montage-, Bedienungs- Und Sicherheitshinweise

You may also make use of cords to secure the
device during transportation.
Transport after use, clean the device and dry.
Follow the step of "Cleaning and are" described
in manual. Click the spray tube
spray tube holder
9
container handle .
2

Cleaning and care

During cleaning, always protect
yourself with wearing suitable personal pro-
tective equipment (PPE) of wearing eye pro-
tection, respiratory protection, appropriate
protective clothing, water-proof gloves and
boots from hazardous substances.
Note: Even after spraying has ended, there
is still residual pressure in the container
to the pressure regulating valve
it, first loosen the pipe connection
move the spray tube
20
the container and point the spray tube
1
handle at the opening of the container
15
Press the spray trigger
pressure over the opening of the container
If the nozzle seems to be blocked, do not try
to blow it free with your mouth.
Note: Clean the pressure sprayer after each use!
Empty the bottle after each use.

Clean the pressure sprayer

The pressure sprayer shall be washed in an
allowed site.
Loosen the spray nozzle
pressure regulating valve and clean under
22
running water.
Loosen the nozzle cap
clean under running water together with the
inner parts of spraying sheet
split sheet , seal washer sheet
33
If the spray nozzle
23
clean it by pushing a needle through it.
onto the
20
(s. fig. I). Carry with the
due
3
. To release
22
and re-
16
. Open the cover of
.
3
to release the residual
17
.
3
, , , from
23 24 25 26
, , , ,
23a 24a 25a 26a
, , ,
23b 24b 25b
.
34
, , , is clogged,
24 25 26
Flush through the pressure sprayer, pressure
regulating valve , pipes and tubes with water.
22
Remove the spray handle
sprayer and disassemble. Clean under running
water together with the filter
ø18.5mm . Pls. use brush for clean the
39
filter (Fig J).
19
Take out the filter screen
water with brush.
The surface and inner part should be cleaned
with high pressure injection water till drainage
become clean (Fig. K). After clean, always
click the spray tube
20
holder (s. fig. I) for transport or storage.
9
After operation and cleaning of product, al-
ways change clothes and wash those exposed
part of body such as hands and face. In case
of toxic pesticide and germicide, a shower after
operation is required to ensure safety.

Store the pressure sprayer

Always release any residual
pressure still present in the container
by following the step of "Emptying the pressure
sprayer and disposal of spray solution"and"
Cleaning and care".
Thoroughly clean the device and allow it to
dry before you put it away for the winter. This
will avoid frost damage.
Clip the spray tube
20
(s. fig. I).
Store the pressure sprayer in a dry, dust-
free place.
Do not store the device in live-
stock buildings due to the ammonia vapours
(danger of brass cracking), do not fill with
solutions containing nitrogen or phosphates.
Check the product regularly each year after
winter by using of clean water. Check product
before each use.
Check the product after each use.
from pressure
15
and O-ring
19
under running
31
onto the spray tube
after use
3
on spray tube holder
9
GB/IE/NI 13