Montage
22
5.8.3
Multischläuche anschließen
M1- Luftschläuche von der pneumatischen Steuereinheit zum Spülblock und Armatur
Anschluss M1 in der pneumatische Steuereinheit
Die Luftschläuche für die Pilotventile befinden sich im Schlauchpaket des Multischlauchs
M1.
1.
Die Schläuche 1,2 und 3 des Multischlauchs M1 in die vorgesehene Kabelverschrau-
bung der pneumatische Steuereinheit führen.
2. Die Schläuche wie folgt an die Pilotventilinsel anschließen:
Pilotventil
1
2
3
Anschluss M1 am Spülblock und Armatur
13
Anschlüsse M1 an Armatur und Spülblock
3. Schlauch 1 an die Druckluftansteuerung für die Armatur in Messenposition anschlie-
ßen.
4. Schlauch 2 an den Anschluss für Druckluftansteuerung für die Armatur in Servicepo-
sition anschließen.
5. Schlauch 3 an die Druckluftansteuerung Prozessventil Wasser des Spülblocks
anschließen.
6. Schlauch 4 (Druckluftansteuerung Prozessventil Spülluft) an das Ventil für die Spül-
luft am Spülblock anschließen.
1.
Funktion
Druckluftansteuerung Arma-
tur Messenposition
Druckluftansteuerung Arma-
tur Serviceposition
Druckluftansteuerung Pro-
zessventil Wasser
2 3
1 4
M1
Liquiline Control CDC90
Schlauch Nummer
1
2
3
Endress+Hauser
A0033431
A0034130