Using The Transmitter; Inserting The Batteries - Reely Mini-Wavebreaker Bedienungsanleitung

9. Using the transmitter

The numbers used in these instructions refer to the illustration alongside the text or the illustrations within
the respective section. For this reason, the same number can represent different locations and different
controls in different figures. Cross-references to other figures are given in the text with the corresponding
figure number.
The figures of the remote control and the model in these operating instructions are for illustrative purposes
only. The label, design and colour scheme of the products supplied in series may differ completely from the
figures in these operating instructions.
a) Inserting the batteries
A 9 V block battery (not included, can be ordered separately) is required to power the transmitter.
Proceed as follows to insert the batteries:
The battery compartment cover (1) is located on the rear
side of the transmitter. Press the corrugated area (2) and
push off the cover downwards.
Insert the 9 V block battery (3) according to specifications
on the bottom of the battery compartment (4), observing
the correct polarity. The lower spring contact (5) must be
connected to the minus pole of the battery.
Then replace the battery compartment cover and push it
upwards until it clicks into place.
34
Figure 3