Cleaning And Hygiene; Fault Finding - Electrolux Dito K25 Bedienungsanleitung

Cleaning and hygiene

4. IN BETWEEN USE
1
• Remove the bowl, cover and the rotor (see § 3.2).
• Using running water or a bowl of water to clean these parts,
using hot water as well as a detergent - degreaser - disinfec-
tant (if working with greasy products).
• Check that the parts have been cleaned properly.
4. AFTER USE
2
• Unplug the machine.
• To remove and clean the rotor, cover and bowl, see § 3.2 and 4.1.
• If necessary, clean the outside of the machine with a damp
sponge and a detergent - disinfectant, paying particular atten-
tion to the rotor drive shaft and the bowl support, then rinse.
Note:
- Use cleaning products that are compatible with the materials
of the machine.
- The drive shaft and the inside of the rotor must be kept per-
fectly clean.
- The bowl and the rotor may be cleaned in a dishwasher if the
blades are protected against impacts.

Fault finding

5. THE MACHINE WILL NOT START, CHECK THAT:
1
• The machine is plugged in.
• The electrical power supply to the socket is correct.
5. ABNORMAL NOISES
2
• Stop the machine.
• Check:
- that the rotor and bowl are fitted correctly.
- that there are no foreign bodies inside the bowl.
5. WORK QUALITY
3
• To obtain perfect and rapid results without overheating:
- always use sharp, undamaged blades,
- use another rotor for delicate work (e.g. chopping of parsley).
- avoid using excessive quantities of products, which may cause
overheating (meat, pastry).
Maintenance
6. MECHANICAL PARTS
1
• The cutter requires a minimum amount of maintenance (the motor
and the mechanical part bearings are greased for life).
• It is recommended to perform the following operations at least
once a year:
- grease, with a grease that is suitable for use with food, the seal
at the bottom of the drive shaft
- the condition of the electrical connections.
• Access to electrical components:
- Unplug the machine.
- Remove the casing.
Note:
- Use cleaning products that are compatible with the plastic
(polycarbonate) and stainless steel parts.
- Do not use abrasive products to clean the transparent cover.
Handle the rotor carefully.
(risk of CUTS, IMPACTS, etc.).
Do not wash the machine with a pressure cleaner.
- In order to avoid acid stains on the rotor blades, we recom-
mend that they be dried thoroughly before putting them away,
and to keep the rotor in a cold place to limit the development
of germs
- After cleaning and drying the lid, the rotor and the bowl, repla-
ce the assembly on the cutter.
• Periodically:
- Clean the dust from the ventilation holes underneath the machine.
• The cover is closed (see § 3.2).
• Remove, clean if necessary and refit.
If the problem persists,
contact the service department of your local dealer.
Note:
- if necessary, redress the edge of the blades on the opposite
side to where they have been sharpened, using the grind-sto-
ne supplied with the machine.
Residual voltage at the capacitor terminals.
• The capacitors may retain an electrical charge. To avoid tak-
ing any risks when carrying out work, we recommend dischar-
ging them by connecting their terminals with an insu-
lated conductor (e.g. a screwdriver).
3
K 25 GB 9 01