Herunterladen Inhalt Inhalt Diese Seite drucken

What If There Are Problems; Disposal - Beurer BM 81 easyLock Gebrauchsanweisung

Oberarm-blutdruckmessgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

10. What if there are problems?

Error
Possible cause
message
Unable to record a pulse.
Er1
You moved or spoke during the measure-
Er2
ment.
The cuff is not attached correctly.
Er3
The measured values are outside the speci-
Er4
fied measurement range.
An error occurred during the measurement.
The inflation pressure is higher than 300
Er5
mmHg.
The batteries are almost empty.
Er6
Unable to transfer the data via Bluetooth
ER7

11. Disposal

Repairing and disposing of the device
• Do not repair or adjust the device yourself. Proper operation can no longer be guaranteed in this case.
• Do not open the device. Failure to comply will invalidate the warranty.
• Repairs must only be carried out by Customer Services or authorised retailers. Before making a claim,
please check the batteries first and replace them if necessary.
• For environmental reasons, do not dispose of the
device in household waste at the end of its service life. Dispose of the device at a suitable local
collection or recycling point in your country. Dispose of the device in accordance with EC Directive
– WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please contact the local
authorities responsible for waste disposal.
Solution
Please wait one minute and repeat the mea-
surement.
Ensure that you do not speak or move during
the measurement.
Please observe the information in chapter
„Attaching the cuff" and take another measu-
rement after one minute.
Please wait one minute and repeat the mea-
surement.
Ensure that you do not speak or move during
the measurement.
If the error occurs repeatedly, consult a doc-
tor to check you are healthy.
Please take another measurement to check
whether the cuff can be correctly inflated.
Make sure that neither your arm nor other
heavy objects are pressing on the line, and
that the line is not bent.
Insert new batteries into the device.
.
Please observe the information in chapter
®
"Transfer of measurements via Bluetooth
33
".
®

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis