Initial Use; Making Settings - Beurer BM 81 easyLock Gebrauchsanweisung

6. Initial use

Inserting the batteries
• Remove the battery compartment lid on the rear of the device.
• Insert four 1.5 V AAA (alkaline type LR03) batteries. Make sure that the batter-
ies are inserted the correct way round.
• Close the battery compartment lid again carefully.
• All display elements are briefly displayed,
date and time as described below.
If the battery replacement symbol
ments and must replace all batteries. Once the batteries have been removed from the device, the date and
time must be set again. Any saved measurements are retained.

Making settings

You must make sure that the device has the correct settings before use in order to be able to make full use of
all functions. Only by doing so can your measurements with associated date and time be saved and accessed
later by you.
There are two different ways to access the menu from which you can adjust the settings:
• Before initial use and after each time you replace the battery:
When inserting batteries into the device, you will be taken to the relevant menu automatically.
• If the batteries have already been inserted:
Press and hold the memory button M on the device when switched off for approx. 5 seconds.
In this menu you can adjust the following settings in succession:
Hour format
➔
The hour format now flashes on the display.
• Using the +/- setting buttons, select your desired hour format and confirm with the M
memory button.
The year flashes on the display.
• Using the +/- setting buttons, select your desired number for the year and confirm with
the M memory button.
The month flashes on the display.
• Using the +/- setting buttons, select your desired month and confirm with the M memory
button.
The day flashes on the display.
• Using the +/- setting buttons, select your desired day and confirm with the M memory
button.
If the hour format is set as 12h, the day/month display sequence is reversed.
is permanently displayed, you can no longer perform any measure-
Date Time ➔ Bluetooth
➔
flashes in the display. Set the
®
➔
25
User