Cleaning And Maintenance; Accessories And Replacement Parts; What If There Are Problems - Beurer BM 51 easyClip Gebrauchsanweisung

8. Cleaning and maintenance

• Clean the device and cuff carefully using only a slightly
damp cloth.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.

9. Accessories and replacement parts

Accessories and replacement parts are available from the
corresponding service address (according to the service
address list). Please state the corresponding order number.
Designation
easyClip universal cuff
(22–42 cm)
Mains part (EU)
Mains part (UK)
Item number and/or
order number
164.183
071.95
072.05
31

10. What if there are problems?

Error Possible cause
message
Unable to record
a pulse.
The cuff was
not attached
correctly.
An error occurred
during measure-
ment.
An error occurred
while pumping up
the cuff.
Solution
Please wait one minute
and repeat the measure-
ment.
Ensure that you do not
speak or move during the
measurement.
Please observe the infor-
mation in chapter 7 under
the heading "Attaching
the cuff".
Please wait one minute
and repeat the measure-
ment.
Ensure that you do not
speak or move during the
measurement.
Please take another
measurement to check
whether the cuff can be
correctly inflated.
Make sure that neither
your arm nor other heavy
objects are pressing on
the line, and that the line
is not bent.