Goodnal STP ST041 General (Buerkert Fluid Control Systems Type 3232 Smart Systems Manual) Vendor Manual
Type 3232, 3233, 3233 K, 3234,
Authorized use
2.
auThOrized use
non-authorized use of the devices may be dangerous to people,
nearby equipment and the environment.
• The diaphragm valves of Types 3232, 3233, 3233 K, 3234, 3235
and 3239 are designed for the control of contaminated, ultra-pure
or sterile media, as well as for abrasive or aggressive media (also
with higher viscosity).
• The devices may be used only for media which do not attack the
housing and seal materials (see type label). Information on the
resistance of materials to the media is available from your Bürkert
sales office.
• During use observe the authorized data, the operating conditions
and conditions of use specified in the contract documents and
operating instructions. These are described in the chapters „Sys-
tem description" and „Technical data".
• The device may be used only in conjunction with third-party devices
and components recommended and authorized by Bürkert.
• Correct transportation, correct storage and installation and care-
ful use and maintenance are essential for reliable and faultless
operation.
• Use the device only as intended.
2.1.
restrictions
If exporting the system/device, observe any existing restrictions.
Q-Pulse Id VM422
3235, 3239
2.2.
predictable Misuse
• Do not introduce media, which attack the housing or seal mate-
rials, into the media connections of the system. The Bürkert
resistance table of materials can be found on the Internet at:
www.burkert.com
• Do not put any loads on the housing (e.g. by placing objects on it
or standing on it).
• Do not make any external modifications to the device housings. Do
not paint the housing parts or screws.
• When closing the valve, tighten it hand-tight only. Overtightening
may prematurely damage the diaphragm.
Active 29/10/2013
Page 14 of 76
english
5