Getting Started; Checking The Contents Of Packing; Prontopress-20; Mounting Unit - struers ProntoPress-20 Benutzerhandbuch

Checking the Contents of
Packing

ProntoPress-20

Mounting Unit

Unpacking ProntoPress-20

Placing ProntoPress-20

Transport Screw Cap

ProntoPress-20
Instruction Manual

1. Getting Started

In the packing box you should find the following parts:
1 ProntoPress-20 machine
1 Swivel arm
1 Pressure hose
1 Filter gasket
1 Gasket
1 Reduction ring with gasket
2 Measuring spoons for mounting resin
1 Funnel
1 Air filter
1 Set of Instruction manuals
1 Mounting unit
1 Top closure with upper ram
1 Lower ram
1 Piston pin
1 Dust protection ring
1 Mould release agent (FASTI)
1 Scraper (PROAN)
ProntoPress-20 is detached from the bottom of the packing case
by removing the four screws from below.
ProntoPress-20 should be placed on a steady table with an
adequate working height. The machine must be placed close to
the power supply, water mains and water outlet facilities. If water
recirculation is used, there must be room under the table for the
Recirculation Cooling Unit (TRECI).
Carry out the following procedure before using the machine for
the first time. Exchange the transport screw cap
enclosed air filter
system.
The transport screw cap
underneath the cover for the mounting unit.
, to equalise the pressure in the hydraulic
with the
is situated
3