Noise Level; Supplying Power; Supplying Water; Water Inlet - struers ProntoPress-20 Benutzerhandbuch

Noise Level

Supplying Power

Supplying Water

Water Inlet

Water inlet
Water outlet tube

Water Outlet

ProntoPress-20
Instruction Manual
The noise level of the machine is 60 dB (A) measured when the
pump is running, at a distance of 1.0 m/39.4" from the machine.
ProntoPress-20 is factory mounted with an electric cable. Mount a
plug on the cable:
Brown: phase
Blue: neutral
Yellow/green: earth
Check that the mains voltage corresponds to the voltage stated on the type
plate on the machine. Do not operate the machine before the transit screw
cap has been exchanged with the enclosed air filter.
Water for cooling may be supplied from the water mains or a
Recirculation Cooling Unit.
Mount the pressure hose onto the water inlet tube (pos.
back of the machine:
Insert the filter gasket in the coupling nut with the flat side
against the pressure hose.
Tighten the coupling nut completely.
Mount the other end of the pressure hose on the water mains tap
for cold water:
Mount the reduction ring with gasket on the water mains tap,
if necessary.
Introduce the gasket and tighten the coupling nut completely.
Lead the water outlet tube (pos.
absolutely sure to place the hose with a steady downward
slope and without any obstructions.
Attach the water outlet tube to the water outlet system.
Important
Important
Only connect to cold water
) to the drain and be
) on the
5