Manual Functions; Heating Of Cylinder - struers ProntoPress-20 Benutzerhandbuch

Manual Functions

Heating of Cylinder

To start heating:
To stop heating:
38
ProntoPress-20
Instruction Manual
The mounting cylinder can be heated without pressure on. It can
be closed or open. This feature can be used as stand by, to reduce
the process time, or for special applications.
Go to the Select Method Group Menu:
SELECT METHOD GROUP
1. STRUERS
3. GROUP NUMBER 3
F1:CONFIG. F3:MAN. FUNC.
If the heading in the display is different, press Esc until the
Select Method Group Menu appears.
Press F3:MAN. FUNC to activate the
F3
manual functions.
D
State: OFF
Pre-set Temperature:
Actual Temperature:
F1:START HEATING
Adjust the pre-set temperature to the desired value. See Method
Edit.
For safety reasons, the temperature can only be selected in the
range 30 to 60°C. The heating is automatically switched off after
1 hour.
Press F1:START HEATING and state
F1
changes to ON.
Press F1:STOP HEATING and State
F1
changes to OFF.
The heating is automatically switched OFF, if manual cooling is
selected or if a mounting process is started.
2. GROUP NUMBER 2
4. GROUP NUMBER 4
F4:RENAME
HEATING OF CYLINDER
50 °C
25 °C