Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Checking the Contents
LaboPress-1
Mounting Unit
Unpacking LaboPress-1
Placing LaboPress-1
Transport Screw Cap
2
LaboPress-1
Instruction Manual
1. Getting Started
In the packing box you should find the following parts:
1
LaboPress-1 machine
2
Measuring spoons for mounting resin
1
Funnel
1
Air filter
1
Set of Instruction Manuals
1
Mounting unit
1
Top closure with upper ram
1
Lower ram
1
Dust protection ring
1
Piston pin
1
Mould release agent (FASTI)
1
Scraper (PROAN)
LaboPress-1 is detached from the bottom of the packing case by
removing the four screws from below.
LaboPress-1 should be placed on a steady table with an adequate
working height. The machine must be placed close to the power
supply, water mains and water outlet facilities.
Carry out the following procedure before using the machine for
the first time. Exchange the transport screw cap
enclosed air filter
system.
The transport screw cap
, to equalise the pressure in the hydraulic
is situated underneath the cover for the
mounting unit.
with the
Werbung
Inhaltsverzeichnis
