Mounting The Water Level Sensor (Accessory) - struers AbraPol-10 Benutzerhandbuch

Mounting the Water Level
Sensor (accessory)
PAMWA
Dummy jack Red tab
AbraPol-10
Instruction Manual
Switch the machine off.
Pull out the Recirculation Cooling Unit.
Remove the pump, drain hose and the top cover.
Remove the red cover from the hole for the sensor or remove
the existing Water Level Indicator.
Remove the locking nut on the bottom of the sensor and slide
off the black float.
Mount the new Water Level Sensor on the Recirculation
Cooling Unit cover and secure using the nut supplied (flat
side of nut up).
Replace the float (with the clear surface up) and secure the
locking nut in place.
On the right hand side of the machine, remove the 4 Allen
screws securing the electrical panel, and let the electrical
panel hang on the two tabs (as illustrated in Supplying
Power).
Remove the dummy jack plug located on the electrical panel
by pressing down the red tab.
Plug in the jack plug from the sensor.
Reassemble the Recirculation Cooling Unit and slide it back
into position.
Replace the front cover.
Switch the machine on.
Nut
Clear surface
Black float
Locking nut
15