Maintenance Of Recirculation Unit; Low Level Warning; Refilling The Cooling Unit; Emptying The Cooling Unit - struers Exotom-100 Gebrauchsanweisung

Maintenance of
Recirculation Unit

Low Level Warning

Refilling the Cooling Unit

Emptying the Cooling Unit

Pump handle
Exotom-100
Instruction Manual
The Exotom-100 will automatically display a warning if the level
of cooling water gets too low. However, it is recommended that the
cooling water level is checked every week.
Refill the cooling unit with water using an external water hose
or via direct connection to the water mains.
Stop refilling when the water level is 5-10 cm from the upper
edge.
Never refill by pouring the water into the cutting chamber, as it would be
impossible to check the increasing level in the tank.
Always maintain the correct concentration of Struers Additive in the cooling
water (percentage stated on the container of the Additive). Remember to
add Struers Additive each time you refill with water.
Use only Struers Additive ADDUN in the Recirculation Cooling Unit.
ADDUN is specially selected for use with Struers cut-off machines.
Other additives may not be compatible with some of the components of
When replacing the cooling water, the cooling unit is emptied
using the recirculation pump. Turn the black pump handle in the
cooling unit compartment to the vertical position to activate the
pump.
By design, the pump cannot empty the tank completely,
preventing cutting waste from entering the cooling system. Tilt
the tank, to release the remaining water.
Remember to turn the pump handle horizontally (off position) after use.
The recirculation pump automatically stops after 8 minutes to avoid pump
damage. To re-start the pump, turn the pump handle horizontally, then re-
activate the pump by turning the pump handle to the vertical position.
NB!
IMPORTANT
the cut-off machine.
IMPORTANT
Note
43