struers AbraPol-10 Benutzerhandbuch Seite 63

Message
START denied method not selected
Manual dosing denied method step
not selected
The following lubricant is not
configured: " xx "
You can not dose with water
Process time or stock removal not
specified (zero)
START denied, selected method or
step is Empty
Tube(s) not selected for cleaning
push knob to select tube(s)"
The following abrasive is not
configured: " xx "
Method name already in use,
please rename the method
AbraPol-10
Instruction Manual
Explanation
A method has not been select.
Manual dosing has been denied
because step has not been
selected.
The lubricant chosen for a certain
preparation has not been
configured and the preparation can
not proceed.
The manual lubricant key has been
pressed in a step where water was
selected.
The step can not start because
neither time nor removal have been
specified.
It is not possible to start a
preparation process from an empty
method or step.
The tube has not been selected and
can therefore not be cleaned.
The abrasive chosen for a certain
preparation has not been
configured and the preparation can
not proceed.
A method name can only be used
once.
Action
Select a method and press start.
Choose a preparation step that
contains the suspension or lubricant
in question.
In the CONFIGURATION MENU it
is possible change the set-op for
the different lubricants.
(See Setup Bottle Configuration)
Use the key for manual dosing
w
of water.
In EDIT METOD STEP specify time
or stock removal.
Chose a method or a step which is
not empty before pressing start.
Push knob to toggle between yes
and no in the select column – yes
must be selected if you want to
clean the tube.
In the CONFIGURATION MENU it
is possible change the set-op for
the different abrasives.
(See Setup Bottle Configuration)
Use a different name.
57