Mounting The Water Supply Kit (Accessory) - struers AbraPol-10 Benutzerhandbuch

Mounting the Water Supply Kit
(accessory)
ABWAT
Cable
W23
Blades
Hose nipple
12
AbraPol-10
Instruction Manual
Disconnect main power.
Remove the lower front cover plate.
Remove the cover plate located on the left side of the machine
with the supplied Allen key, and break loose the plug.
Mount the water solenoid valve with the supplied Allen bolts
and key according to the type plate.
Connect the two blades (cable W23) to the solenoid.
Connect the reinforced hose from the doser arm to the hose
nipple, and tighten the clamp.
Be careful that the hose does not interfere with the belts.
Remount the cover plate.
Connect the white hose to the solenoid valve.
Mount the straight end of the pressure hose onto the water
inlet tube on the back of AbraPol-10:
−
Insert the filter gasket in the coupling nut with the flat
side against the pressure hose.
− Tighten the coupling nut completely.
Mount the other end of the pressure hose on the water mains
tap for cold water:
− Mount the reduction ring with gasket on the water mains
tap, if necessary.
−
Introduce the gasket and tighten the coupling nut
completely.
Replace the front cover and reconnect the main power.