Mounting A Drip Lubricator; Mounting A Labodoser Dosing Unit - struers LaboForce-3 Gebrauchsanweisung

Mounting a Drip Lubricator

(Accessory)
Mounting a LaboDoser Dosing
Unit (Accessory)
LaboForce-3
Instruction Manual
The drip lubricator can be mounted on LaboForce-3 to supply the
necessary lubricant during the preparation process.
 Remove the drip lubricator from its box.
 Loosen the finger screw underneath LaboForce-3.
 Guide the bottom plate of the drip lubricator onto the finger
screw and the positioning pin underneath the LaboForce-3, and
tighten the finger screw again.
 Hold the lubricant bottle with one hand and remove the top lid.
 Fill the bottle with lubricant.
 Place the lid on the bottle and the drip lubricator is ready to
use.
Follow the Instructions for Use that are supplied with the Dosing
Unit.
5