HBM S2M Serie Montageanleitung Seite 23

S2M
S Load the transducer with 110% of the force that will
occur during subsequent operation in the tensile direc­
tion.
S Tighten the locknut by hand.
S Relieve the load on the transducer.
2. Installation of knuckle eye and locking with torque:
S Rotate the locknut back to the eye.
S Screw the knuckle eye completely into the transducer.
S Align the knuckle eye.
S Tighten the locknut with a torque of 15 Nm.
Notice
When locking, the tightening torque must not be shunted
through the transducer.
A3592-1.3 HBM: public
Mechanical installation
21