Alterations To The Power Source; Spares And Wearing Parts; Calibration Of Power Sources; Ce-Marking - Fronius Transpocket 1500 Erdstrom Serviceanleitung, Ersatzteilliste

Alterations to the
power source
Spares and
wearing parts
Calibration of
power sources

CE-marking

Copyright

Do not make any alterations, installations or modifications to the welding
machine without getting permission from the manufacturer first.
Replace immediately any components that are not in perfect condition.
Use only original spares and wearing parts. With parts sourced from other
suppliers, there is no certainty that these parts will have been designed and
manufactured to cope with the stressing and safety requirements that will be
made of them.
When ordering spare parts, please state the exact designation and the
relevant part number, as given in the spare parts list. Please also quote the
serial number of your power source.
In view of international standards, regular calibration of power sources is
advisable. Fronius recommends a 12-month calibration interval. For more
information, please contact your Fronius partner!
The power source fulfils the fundamental requirements of the Low-Voltage
and Electromagnetic Compatibility Directive and is thus CE-marked.
Copyright to this service manual remains the property of Fronius
International GmbH.
Text and illustrations are all technically correct at the time of going to print.
The right to effect modifications is reserved. The contents of the service
manual shall not provide the basis for any claims whatever on the part of the
purchaser. If you have any suggestions for improvement, or can point out to
us any mistakes which you may have found in the manual, we should be
most grateful to you.
13