Closing The Housing - Fronius Transpocket 1500 Erdstrom Serviceanleitung, Ersatzteilliste

Fitting the fan
(80)
(continued)
Fig.11
Fig.12
Closing the
housing
Fig.13
(34)
Fig.14
(81)
(5) (40) (33) (41)
(21) (37)
(36)
(35)
- Insert the following cables into the 10-
(41)
pole Molex plug (41):
- Fan lead, red (80), Pin 1
- Fan lead, black (81), Pin 2
- Plug the 10-pole Molex plug (41) onto
(42)
board LCA15
- Plug the 2-pole Molex plug (40) onto
board LCA15
- Fix the cable harness for 2-pole Molex
plug (40) and 10-pole Molex plug (41)
with a cable binder.
Note! Before plugging in the
ribbon cable (42), pass it across
the cable harness for Molex
plugs (40) and (41), as shown in
Fig. 12.
- Arrange the ribbon cable (42) above
the cable harness, as shown in Fig.12
- Plug the ribbon cable (42) to board
FPA15 (5)
- Insert the board insulator (37)
- Insert the housing stiffening element
(21)
- Plug the "housing earth conductor" (36)
onto the housing box, in the correct
position
- Replace the housing box
- Screw the 5x25-TX20 screw (35) back
onto the rear of the housing
- Screw the 5x25-TX20 screw (34) back
onto the front of the housing
- Fit the carrying strap back on again
91