Utilisation For Intended Purpose Only; Ambient Conditions; Obligations Of Owner/Operator; Obligations Of Personnel - Fronius Transpocket 1500 Erdstrom Serviceanleitung, Ersatzteilliste

Utilisation for
intended purpose
only
Ambient
conditions
Obligations of
owner/operator
Obligations of
personnel
The power source may only be used for jobs as defined by the "Intended
purpose" (see the section of the Operating Instructions headed "Starting to
use the welding machine").
Utilisation in accordance with the "Intended purpose" also comprises
- following all the instructions given in this service manual
- performing all stipulated inspection and servicing work
- exact compliance with the prescribed measurement, testing and
corrective maintenance work described herein.
The power source is designed to be used in industrial and workshop
environments. The manufacturer shall not be liable for any damage resulting
from use of the power source in residential premises.
Operation or storage of the power source outside of the stipulated range is
deemed to be "not in accordance with the intended use". The manufacturer
shall not be liable for any damage resulting herefrom.
Temperature range of ambient air:
- when welding: - 10 °C to + 40 °C
- when being transported or stored: - 25 °C to + 55 °C
Relative atmospheric humidity:
- up to 50 % (at 40 °C)
- up to 90 % (at 20 °C)
Ambient air: Free of dust, acids, corrosive gases or substances etc.
Elevation above sea level: Up to 2000 m
The owner/operator undertakes to ensure that the only persons allowed to
work with the power source are persons who
- are familiar with the basic regulations on workplace safety and accident
prevention, and who have been instructed in how to operate the power
source
- have read and understood the sections on safety rules and the warnings
contained in this service manual, and have confirmed as much with their
signatures
Regular checks must be performed to ensure that personnel are still working
in a safety-conscious manner.
Before starting work, all persons entrusted with carrying out work on the
power source shall undertake
- to observe the basic regulations on workplace safety and accident
prevention
- to read the sections on safety rules and the warnings contained in this
service manual, and to sign to confirm that they have understood these
All workplaces must be inspected and checked regularly after work has
finished.
8