Fitting The Handle To The Power Source - Fronius TransPocket 4000 CEL Bedienungsanleitung

Straighten the locking devices and secure them
Fitting the handle
to the power
source
Allow the handle plates to engage
IMPORTANT! When fitting the two handle plates (1) together, make sure that the locking
devices (2) on the underside of the handle plates (1) are fully engaged.
(10)
(10)
Secure the handle plates and the handle tube using
"Extrude-Tite" screws
3
IMPORTANT! To secure the two handle plates (1) in the centre, place two Extrude-Tite
screws on one side (9) and two Extrude-Tite screws on the other side (10), so that the
screw heads are each on the side with the larger hole.
4
82
(4)
(3)
(1) (2) (2)
(3) (4) (1) (5)
(9)
(9)
Secure the handle plates (1) to the top using four Extrude-Tite screws (5) and (7)
Secure the handle plates (1) together in the centre using four Extrude-Tite screws (9)
and (10)
7
(4)
8
9
(3) (3)
(1) (2)
(2)
Handle plates and handle tube
1
(6) (7) (8)
2
IMPORTANT! To fix the handle plates (1)
on the top, place two Extrude-Tite screws
on one side (5) and two Extrude-Tite
screws on the other side (7), so that the
screw heads are each on the side with the
larger hole.
Straighten the locking devices by mo-
ving the outer threaded bolts (4) as far
as they will go
Tighten the six wing nuts (3)
Carefully place the trolley with power
source on its wheels
(3)
(1)
Allow the handle plates (1) to engage
on the power source handle (4) using
the locking devices (2)
Insert the cotter pin (8) of the handle
tube (3) into the guides (6) of both
handle plates
(1)