Fitting The Seal For The Remote-Control Unit Connection Socket - Fronius Transpocket 1500 Erdstrom Serviceanleitung, Ersatzteilliste

Fitting the
welding sockets
(continued)
Fig.18
Fig.19
Fitting the seal
for the remote-
control unit
connection
socket
(7)
Fig.20
- TP 1500 RC / 1500 TIG: Apply a thin film of lubricant to the seal (7) for the remote-
- TP 1500 RC / 1500 TIG: Gently press the seal (7) for the remote-control unit
- To begin with, snap the FPA15 (5) into place on the rear alignment pin
Note! Before placing the FPA15 board (5) onto the alignment pins, do the
following:
control unit connection socket (Fig.21)
connection socket, to prevent it being forced out when the FPA15 board is pushed
into place
- TP 1500 TIG: Loosely screw on the
(69)
hexagon nut (69) (width-across = 13)
(93)
of the threaded join between the
socket and the copper bracket.
Note! TP 1500 TIG: Use a new
hose clamp (18) to fasten the gas
hose (17).
(18)
- TP 1500 TIG: Push the gas hose (17)
onto the gas connector (93) of the
(17)
socket and fasten it with a hose clamp
(18) (Fig.17)
- Carefully insert the seal (7) for the
remote-control unit connection socket
into the front of the housing
111