Installation; General; Connecting The Interconnecting Hosepack To The Tig Power Source - Fronius PlasmaModule 10 Bedienungsanleitung

Installation

General

The installation of a plasma welding system depends on many factors, e.g.:
-
-
-
-
-
-
For detailed information on the work steps, please refer to the documentation for
the individual components.
Installation
An electric shock can be fatal.
If the device is plugged into the mains during installation, there is a high risk of very
serious injury and damage. Only carry out work on the device when
▶
▶
Falling equipment can cause injury.
Make sure PlasmaModule 10 and the PlasmaModule holder stand firmly.
1
Connecting the TransTig 2500 / 3000
interconnecting
hosepack to the
TIG power source
Connecting the interconnecting hosepack to the TIG power source TransTig 2500 / 3000
TransTig 4000 / 5000 with FK 4000 R
74
Application
the material to be welded
the available space
influences of robots and robot control system or other automation apparatus
accessibility
Environmental conditions
WARNING!
the mains switch is in the "O" position,
the device is unplugged from the mains.
CAUTION!
Set up the individual components of the plasma welding system according to the
intended application (see also the section "Configuration examples")