Troubleshooting - Profitec Pro 800 Bedienungsanleitung

11. TROUBLESHOOTING

Problem
Little or no crema on the top of
the coffee
Little or no crema on top of the
coffee
Sparse coffee dispensing, only
drop by drop
Foam instead of crema
The machine is switched on, but
the machine does not work.
The machine is switched on, but
the machine does not work.
The machine does not stop
working and takes in air.
Portafilter/ brew group is
dripping.
Translation of the original German user manual
Possible Cause
The grind is not fine enough.
The coffee is too old.
There is too much chlorine in the
water.
The amount of ground coffee is
not enough.
The grind is too fine.
There is too much ground
coffee.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The beans are improper.
The setting of the coffee grinder
is not suited for the coffee
beans in use.
PID-display is turned off: There
is not enough water in the fresh
water tank.
Water has been refilled, PID-
display is off.
The floater is not in the correct
position.
The water tank is not situated
properly.
Machine in use with direct water
connection, but switch in
tank). Machine does not take in
water.
Machine in use with water tank,
position direct water
connection).
Portafilter is not fixed properly.
Group gasket is broken.
Troubleshooting
Use a finer grind.
Tamp the ground coffee more
firmly.
Use fresh coffee.
Use a chlorine filter.
Use the right coffee amount:
Approx. 7g 9g of coffee for
each cup.
Set a coarser grind.
Tamp ground coffee only
slightly.
Use approx. 7g 9 g of coffee for
every cup.
Set a finer grind.
Use fresh coffee.
Use approx. 7g 9g of coffee for
each cup.
Clean the shower screen.
Use another type of coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)
Refill water.
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet
point on the lower part of the
floater side).
Situate the water tank properly.
direct water connection.
The switch is located behind the
drip tray.
direct water connection.
The switch is located behind the
drip tray.
Fix the portafilter properly.
Change group gasket and
shower screen.
ENGLISH
34