Machine In Use With Direct Water Connection; Programming The Temperature Via The Pid-Display; Pid-Menu - Profitec Pro 800 Bedienungsanleitung

6 The machine is now ready for use.
7 Put the portafilter into the brew group to heat it to an optimal temperature.
Caution danger of injury!
If the portafilter is not inserted properly, there is a great risk of injury. Never remove the
portafilter when there is remaining pressure in the piston of the brew group.
Caution!
Please use the included portafilters only. Otherwise there is a danger of injury.
6.1.2

Machine in use with direct water connection

1 Please make sure that there is always water pressure in the water connection line.
2 Now turn the machine on (the metal switch in the upper position and the right switch behind the drip
3 Wait until the gauge indicates a value of 1.0 bar (0.1 MPa) 1.25 bar (0,125 MPa.
4 In general, the machine will be heated up in about 40 minutes, depending on the ambient
temperature.
5 The machine is now ready to use.
6 Put the portafilter into the brew group to heat it to an optimal temperature.
It is recommended to leave the portafilter in the brew group, keeping it warm for an
optimum temperature for coffee dispension.
If you would like to plumb your machine, installation through a qualified service
technician is required.

6.2 Programming the temperature via the PID-display

6.2.1

PID-menu

PID menu sequence
124
Temperature value
t1
Temperature setting
ECo
ECO mode
o
Temperature mode
When the desired value has been reached, wait a short time and you will exit the menu automatically
Translation of the original German user manual
Selec Mode
tion
t1
ECo
o
Action Change of setting
Temperature value is increased
Temperature value is reduced
Programming in steps of 30. Adjustable
time between 0 and 600 min
Selection between C for Celcius and F for
Fahrenheit
ENGLISH
27