Label; Sensor Slots X-Am 3500; Operation; Symbol Explanations - Dräger X-am 3500 Gebrauchsanweisung

|
en

Operation

Approval-related accessories:
This chapter contains an overview of the key parts covered by
the BVS and PFG certification. Information on other parts can
be found in the spare parts list or can be requested from
Dräger Service. The same ambient conditions that apply for
the gas detector also apply for the accessory. For further
information see: "Gas detector", page 42.
Description
Carrying strap
Calibration adapter
Pump adapter with dust and
water filter
Induction charger
The data logger is not part of the technical suitability test.
3.5

Label

The energy supply label has a mark for a service label. Here,
a maximum of one service label and one year-point label may
be attached one on top of the other. Further labels, conductive
labels or labels with conductive material or parts can have a
negative effect on inductive charging.
The rating plate on the gas detector must not be
concealed.
3.6

Sensor slots X-am 3500

Term
Sensor slot
HPP 1 (High Power Port)
HPP 2 (High Power Port)
EC 1-3 (Electro Chemical)
4 Operation
4.1 Operating concept
Navigation is done with the 3 multifeature buttons and the
dynamic navigation bar (see Graphic E on the fold-out page).
The navigation bar changes dynamically depending on the
available interactions.
4.2

Symbol explanations

4.2.1 feature buttons

Symbol Explanation
Confirm action/dialog / return to menu
Confirm all
Scroll up / through display
Scroll down / through display
28
Part number
8326823
8326821
8326820
8325825

Configuration

not assigned
CatEx sensor
EC sensors
Symbol Explanation
Cancel action
Display quick menu
Display measuring channels individually
Display all measuring channels
Increase value
Decrease value
Repeat feature
Display menu

4.2.2 Displays

Symbol Explanation
Horn and vibration for gas alarm deacti-
vated

4.2.3 Application

Symbol Explanation
Messen
Fresh air calibration
Bump test or calibration

4.2.4 Device status

Symbol Explanation
Overview of the bump test intervals acti-
vated (additional information for the D-Light
feature).
There are no gas alarms or errors.
Monitoring of the calibration intervals acti-
vated, D-Light function deactivated (addi-
tional information for the D-Light function).
There are no gas alarms or errors.
Alarm message
Warning message
The gas detector can be operated nor-
mally. If the warning message is still dis-
played after operation, the gas detector
requires maintenance. Menu Messages
displays details.
Fault message
The gas detector or measuring channel is
not ready to measure and requires mainte-
nance. Menu Messages displays details.
Information message
Menu Messages displays details.
STEL alarm message
Instructions for use
®
|
X-am 3500