Controller Malfunction And Servicing - flamco MeiTronic W10B Bedienungsanleitung

CONTROLLER MALFUNCTION
In the event of malfunction or damage, you can remove controller module from its
base. You do not have to disconnect the connected conductors.
Picture 1
First unscrew the screw (A) and remove the cover (B). Then unscrew the fastening
screw (C). Hold the controller (D) in the height of connectors and pull it from the base.
The base stays attached to the wall along with all the connected cables.
We provide module replacements or deliver the replacement module to an authorised
service.
Before you start uninstalling the controller from its base, always check if the
main switch is off.
Installation manual
AND SERVICING
Picture 2
EN
95