Operating Mode Selection - flamco MeiTronic W10B Bedienungsanleitung

OPERATING MODE SELECTION

In the menu, select the desired operation mode of the controller separate for each
heating circuit and for d. h. w. warming. You can select operation modes from the
menu for the following:
THE FIRST HEATING CIRCUIT
THE SECOND HEATING CIRCUIT *
DOMESTIC HOT WATER
SWITCH-OVER BETWEEN HEATING AND COOLING
MANUAL OPERATION OF OUTPUTS
CHIMNEY SWEEP
OPERATION MODE FOR THE FIRST AND THE SECOND HEATING
CIRCUIT:
Operation mode according to day temperature
The controller operates according to the desired day temperature.
Operation mode according to night temperature
The controller operates according to the desired night temperature.
Switch-off
The controller is switched off, while frost protection remains active,
if operation mode heating is selected, or protection against overheating
(30 °C), if operation mode cooling is selected.
OPERATION MODES FOR D. H. W.:
D. h. w. warming according to selected time program
D. h. w. is warmed according to the selected time program.
Permanent activation of d. h. w. warming
D. h. w. warming functions continuously.
Switch-off
D. h. w. is not being warmed.
*The menu is only available by schemes with two heating circuits.
User Manual
Operation according to selected time program
Operation proceeds according to the selected time program.
If room unit is switched on, the icon
indicates which room unit influences the circuit). If the controller
functions without room unit, only the
EN
appears (The number
icon will appear.
27